BTGuard + Deluge = Can't check my IP torrent with proxy

[cptnemo]

I have installed Deluge on my Debian server and access it via Mac client. I set BTGuard as my proxy. Everything seems to work normally. I tested download few torrents with the proxy set up and they work. What I can't do is to check my ip torrent on checkmytorrentip.com. Even if the tracker status on Deluge says

checkmytorrentip.com: Announce Sent

the web page still report

Your torrent IP has not been detected yet. \n Make sure you've started the torrent and then refresh.\n Your torrent software will share its IP every 60 seconds.

. I tried then to switch the proxy off and redo the IP detection. This time checkmytorrentip.com will work and confirm my ip on its page. Any idea?

[Cas]

Have you tried this: http://forum.deluge-torrent.org/viewtop ... =7&t=43559

[cptnemo]

Yes, I tried changing proxy.guard.com to fix.btguard.com but the problem persists. I can download torrents with no problem, but I can't check my proxy IP with checkmytorrentip.com: the site even after deluge confirms "checkmytorrentip.com: Announce Sent" on their torrent file, keeps saying "Your torrent IP has not been detected yet"

[cptnemo]

I finally managed to get my ip from checkmytorrentip.com. I just needed to wait 10 mins with the torrent on before their website could pick up my IP.

[sdpiuser]

I too am attempting to use BTGuard + deluge with my Raspberry pi..

When I run the deluge-web from the pi and from the web brouser put in my IP with the port..

I can see deluge fine.. but attempting to enter under preferences the proxy I can only see the Peer, Web seed and the first line of tracker... I know there is more but I can't see it... and no slider on the side to make it available..

I haven't got as far as trying to get checkmyip to start.. wonder if anyone else has this issue or what I can do to get all the proxy information in.. isn't there a DHT section too?

[sdpiuser]

OK found out I can't do it in the WebIU but I can in the Thinclient... strange indeed...

So now I wonder if it works with the webIU going right into the raspberry pi.. anyone know how to check?