AutoAdd - error soon after starting download
Posted: Sun Jun 28, 2015 9:14 am
Hi all, I am new to Deluge so please bear with me 
I have a fresh install with AutoAdd set up - upon adding a *.torrent file into one of my configured watch directories, the torrent will load into the UI and start downloading. Within a matter of seconds, I then get the error "The process cannot access the file because it is being used by another process", which then references the folder/file in question. The download then halts.
The same *.torrent will work fine if I manually add it and manually select a Download Location and Move Completed Location. However, this is obviously a lot more laborious than simply adding a *.torrent file to a watched folder of my choosing.
I believe that perhaps the mover process is trying to move the file prematurely, and is jamming up the download.
Any ideas?
I have a fresh install with AutoAdd set up - upon adding a *.torrent file into one of my configured watch directories, the torrent will load into the UI and start downloading. Within a matter of seconds, I then get the error "The process cannot access the file because it is being used by another process", which then references the folder/file in question. The download then halts.
The same *.torrent will work fine if I manually add it and manually select a Download Location and Move Completed Location. However, this is obviously a lot more laborious than simply adding a *.torrent file to a watched folder of my choosing.
I believe that perhaps the mover process is trying to move the file prematurely, and is jamming up the download.
Any ideas?