Page 1 of 1

Thin Client on 2.x

Posted: Tue Feb 12, 2019 1:18 pm
by tugurlann

Has anyone tried to set up 2.x as a thin client / headless daemon?

If so, what should one look out for, compared with the guide for 1.x at ... ThinClient

Thank you.

Re: Thin Client on 2.x

Posted: Thu Jul 04, 2019 11:45 pm
by papagoejoe
I use it like that. I run the docker image, and it is really easy.

You can just fire up the container and visit the webui in a browser. From there you can change the password and enable remote connections.

Then configure your client as described in Client Setup. Use localclient as username or you can add a new user like described in Add User to the authentication file but make sure you edit the auth file that is found in the location you have mounted as the /config folder of your docker container.