Column setup not saved
Re: column setup not saved
Thanks again, but you seem to be very knowledgeable, at least much more than me, and I don't understand what you mean by enabling logging, what devs mean. Could you explain a bit better? Or is there something less complicated one can do?
Re: column setup not saved
devs = developers AKA the people who created / work on / fix Deluge.
Logging: http://dev.deluge-torrent.org/wiki/Trou ... ugeLogging
Simplified info on logging: http://forum.deluge-torrent.org/viewtop ... 12&t=53957
Logging: http://dev.deluge-torrent.org/wiki/Trou ... ugeLogging
Simplified info on logging: http://forum.deluge-torrent.org/viewtop ... 12&t=53957
Re: column setup not saved
I finally was able to run Onyx to repair permissions, if that is what you meant. It seemed to repair oodles of Printer permissions, but no Deluge that I could see.
I hate Terminal, very uncomfortable using it, but I'm willing to give it a try. As per your instructions, should I enable logging to shell or to file, not that I know the difference.
I hate Terminal, very uncomfortable using it, but I'm willing to give it a try. As per your instructions, should I enable logging to shell or to file, not that I know the difference.
Re: column setup not saved
I think file just saves the output for you.
Re: column setup not saved
@ Shryp. So you're saying I should enable logging to shell?
Re: column setup not saved
Either should work.
Re: column setup not saved
I copied the Terminal instructions from the Deluge Troubleshooting page = deluge -L <loglevel> -l <logfile>
to my Terminal and got this = -bash: syntax error near unexpected token `newline'
Since I have no idea what I'm doing, could anyone shed some light here.
to my Terminal and got this = -bash: syntax error near unexpected token `newline'
Since I have no idea what I'm doing, could anyone shed some light here.
Re: column setup not saved
You replace <loglevel> and <logfile> with your own values...
Code: Select all
deluge -L debug -l /path/to/file
Re: column setup not saved
@ Cas. Are you saying to copy what you wrote into Terminal: deluge -L debug -L /path/to/file?
Re: column setup not saved
Well I copied what Cas wrote in his last post. Result: -bash: deluge: command not found.